Installation tools:
For hoses, rubber washers, showers, drains, crutches, decorative caps, etc., each time you need to check whether the supporting parts are complete before installation.
installation steps:
1. Installation of single hole basin faucet
When buying a single-handle basin faucet, you should pay attention to the diameter of the spout. Most of the water inlets on the market are hard pipes, so you should pay attention to the reserved upper spout.
The height is suitable for 35 working points from the bottom of the basin. During installation, a special angle valve must be selected, and the angle valve must be fixed to the hot and cold water pipes out of the wall. When you send
When there is a distance between the angle valve and the water pipe on the faucet, buy a special extension pipe to connect it. Remember,—Do not use other water pipes to connect, because if the water
If it is big, it will easily fall off and leak water, causing you loss. If the inlet pipe is too long to exceed the outlet pipe, you can cut off the part according to your needs.
If appropriate, it can be bent to the position you need. Remember: Do not bend hard to 90 degrees or more than 90 degrees. When installing the basin to drain, please don’t
Forget to buy the small connector of the faucet (short-circuit the faucet). Please don’t forget to flush the water pipes buried in the wall before you install it.
2. Installation of shower and bathtub faucets (wall hanging)
After you have purchased a shower, bathtub, or wall-mounted faucet, you can choose a suitable height to bury the water pipe. The distance between the hot and cold water pipes must reach 15 km
point. Before installation, you must not forget to flush the water pipe to prevent the water from being too hard and causing damage to the faucet.
3. Concealed shower and bathtub faucet
After purchasing a concealed faucet, the valve core of the faucet is generally pre-buried in the wall. Before embedding, pay attention to the thickness of the bathroom wall. If the wall is too thin, the valve
The core will not be pre-buried. Do not remove the plastic protective cover of the valve core easily during pre-embedding, so as to avoid damage to the valve core by cement and other chores during pre-embedding. In addition to the embedded spool
Attention should also be paid to the up and down and left and right directions of the spool to prevent the spool from being buried incorrectly. The size of the wall-mounted faucet is pre-embedded in the water inlet pipe, which can be adjusted and adjusted
The kidnapper conducts schooling.
4. Installation of thermostatic faucet
Before installing the thermostatic faucet, please check first-whether the lower water pipe is hot on the left and cold on the right. Remember not to connect the hot and cold water pipes wrongly to prevent the faucet from not working properly.
do. Gas and solar water heaters cannot use thermostatic faucets because the water pressure is too low. Don’t forget to install the hot and cold water filter when installing the thermostatic faucet.
Post time: Sep-10-2021